This guide presents state-of-the-art information relative to the construction of slab-on-ground and suspended-slab floors for industrial, commercial, and institutional buildings. It is applicable to the …

This guide covers the design of slabs-on-ground for loads from material stored directly on the slab, storage rack loads, and static and dynamic loads associated with equipment and vehicles.

Tilt-up concrete construction is commonly used in low-rise building construction. This guide discusses many of the issues relating to the planning and construction of these buildings to produce a quality tilt …

Additional Definitions Back shores – shores placed under a slab or structural member after the original formwork and shores have been removed from a small area without allowing the entire slab or …

The resulting shear capacity will be less than calculated in ACI 318-14, especially if the design section has a low ρ as is likely in double-tee flanges, other precast slab elements, or cast-in-place slabs.

Conventional saw cuts should generally be made to one-fourth the depth of the slab (ACI 327R-14), although early-entry saws can cut to a lesser depth and still be effective (ACI 224.4R-13). In terms of …

Concrete Breakout Failure Cone Is breakout failure relevant for large-scale connections involving groups of anchors or reinforcing bars?

Difference between a contraction joint, isolation joint, expansion joint, construction joint, and a cold joint Q. What is the difference between a contraction joint, isolation joint, expansion joint, construction …

Tests have established that punching shear in slabs can be effectively resisted by reinforcement consisting of vertical rods mechanically anchored at the top and bottom of slabs. ACI 318 sets out …

Preview Description This guide presents analysis methods, design procedures, slab reinforcement and detailing practices, and strength and serviceability considerations, as well as information for the …